Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - Anybody had this problem? Binding holes not aligned
View Single Post
post #1 of (permalink) Old 01-08-2009, 12:17 AM
Posts: n/a
Mentioned: Post(s)
Tagged: Thread(s)
Quoted: Post(s)
Anybody had this problem? Binding holes not aligned

I recently picked up a new board (Burton Mayhem), and went with the default stance width for the first day out. When I got back in, I wanted to widen the stance by an inch, but the holes on on the board were slightly off from the holes on the binding plate (Burton 3D).

The default width was fine with the 3-hole configuration, but none of the 4-hole configurations lined up correctly.

Anyone had or heard of this problem before? I'm thinking of bringing the board to the local shop and seeing if they have some other discs that might fit better. Any thoughts?

Attached Images
File Type: jpg IMG_0827-1.jpg (46.0 KB, 108 views)
Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome