Did I wax correctly?
Ok so I waxed a board for the first time ever..
I turned the iron on and let it heat up to the correct temp.
I dripped the wax over the board. I think I used too much but oh well (Almost half a block of that burton stuff so about 35 grams)
I then proceeded to iron it out. I did not let the iron sit in one place. I kept it moving and ironed out the wax. I did this for about 8 minutes. The topsheet of my board got warm but not hot. The wax never smoked. However is it ok that the iron touched the base a few times when I was spreading the wax? (meaning when the wax drops need to be spread out is it ok the iron touched some of the unwaxed surface of the base?) Again the iron never stayed in one place.
Did I wax right?
Burton Super Hero 2013 151cm, Union Force Bindings 2013, Burton Hail Boots.