Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - How would you repair this?
View Single Post
Old 02-11-2014, 05:53 PM   #4 (permalink)
Steezus Christ
Senior Member
 
Steezus Christ's Avatar
 
Join Date: Jul 2013
Posts: 274
Default

lol no dont bother trying to warranty.. that happened to my bros heritage and it was a quick fix. just make a small incision over the bulge with an exacto knife then heat it up with a heat gun and take to it with a mallet/hammer until its flush/flat again. you may have to use a chisel type of thing but there's higher risk that the edge will crack completely. once its flush just epoxy over the side if there is any gaps to prevent water from getting in and p-tex over the incision.
Steezus Christ is offline   Reply With Quote