Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - Did Burton change base plates between '06 and '08?
View Single Post
Old 02-28-2008, 09:34 AM   #10 (permalink)
Senior Member
NYCboarder's Avatar
Join Date: Jan 2008
Location: Staten island, NY
Posts: 673

ok i got those plates. but on my burton board where it says centered stance i cant get the holes to line up to insert 4 screws.. not even three.. so i had to widen my stance 1 hole to get 3 in the hole config i believe looks like this
i believe it is the set up not 100% sure i dont have the board in front of me at the moment

-::-::- or -:-:- i think its the second 1 if you can picture it the -'s represent just 1 single hole midline
NYCboarder is offline   Reply With Quote