Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - Burton Custom X Riding Issues
View Single Post
post #12 of (permalink) Old 12-25-2011, 12:44 AM
Veteran Member
lonerider's Avatar
Join Date: Apr 2009
Location: Mountain View, CA
Posts: 947
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Originally Posted by jamesdthomas2 View Post
Went out today. I did not see everyone post before I left. So, I moved my bindings all the way in and set up binding for a more directional feel. The temp was 31 degrees. I did not fall at all today (back to normal) but the board only rode ok. It felt a little sloppy but I am getting adjusted to that feel now.

qwezcx12, Thank you so much for the pics. You are awesome. I recently changed my foward lean in the binding because I couldn't ollie off boxes. When I changed this to no lean, I was able to jump without starting a heel edge (I don't know if I made sense there). I will check that out next time. I see a slight difference in high back angle (see pic). Older Cartels on more of a lean when set to zero. I think you may be on to something.

As far as edges go, I am completely lost. I did look at both edges, but I just see edges... lol. I do tune my own board but I just run the shapener along the side (I hope that's not a dumb comment). I did just pick up a diamond file from sheels. Do you think that makes a huge difference? Do you use is only on the bottom of the board or both bottom and sides?

Lonerider- I was thinking the same thing about my heel cup touching the snow. I wear a size 11.5 boot. The guy who sold me the board said I did not need a wide. So my Twin is a wide and the custom x is not. cx12 is riding a wide custom x. Do you think I made a mistake here? If so, what can I do to minimize this mistake? It's ok...I can take it... I think. It just 600 dollars down the drain
Usually a wide board is recommended for size 11 boot and up (unless you get one of those minus-one boots). You are at the borderline of what I consider to be too much overhang (0.5 - 1 inch), so it is a possibility (but I'm not 100% sure)... especially on a steep slope where you are more likely to angle the board a lot on a heeledge.

Last edited by lonerider; 12-25-2011 at 02:40 AM.
lonerider is offline  
Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome