Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - Engraving a top sheet?
View Single Post
post #6 of (permalink) Old 01-06-2012, 03:01 PM
zk0ot
Veteran Member
 
zk0ot's Avatar
 
Join Date: Nov 2009
Location: WIS
Posts: 957
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 3 Post(s)
Quote:
Originally Posted by EatRideSleep View Post

Interesting...does 'hand engraved' mean with a power tool (like a Dremel) or hand tool?

It's not capped. I haven't considered putting it on the side wall because I thought there was a greater chance of it getting marred there. The problem with putting it near the nose or tail (I think, could be wrong) is that since it's a Mervin board, it's not fully wrapped. And like the side wall, it might have a greater chance of being damaged there (?)

Thanks for the responses so far!
ya looked like a dremel.

.... one of mervins only faults IMO. I dont see how an edge being there would make a difference. i only refferred that spot becuase it gets very little contact. As for the side walls you can be a little more strategous than right in the middle. like near the toe or heel of the binding. a bit more protected there

idk just opinions... you could even get a scribe and do it by hand in the top sheet.

BUCK FURTON
zk0ot is offline  
 
 
Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome