Adam C
Feb 2 (1 day ago)
to Sarah
Thanks for the quick response but I'm not sure what you mean. For example burton boards say 1 deg edge and side bevel on the topsheet.
So the side bevel on the T. Rice is 0 deg the entire length? The base bevel is 0 deg except the contact points which are 3 deg? So I only need to sharpen the humps on the base edge with a 3 deg bevel? 3 seems a lot but if that is factory I'll keep it.
Also the mtx tuning tool is preset 2 deg so I'm confused.
Thanks for your help,
Adam
Sarah.Adkins@mervin.com
Feb 2 (1 day ago)
to me
Hi Adam,
It’s 0 degrees for the side and base edge along the entire length of the board, except at the contact points there is a 3 degree base bevel. It’s likely the MTX tool only goes to 2 degrees because T.Rice is the only board that has that 3 degree bevel.
Thanks,
Sarah