Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - Binding Position Across The Board
View Single Post
post #1 of (permalink) Old 07-14-2012, 12:31 AM Thread Starter
Junior Member
Join Date: Jul 2012
Posts: 17
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Binding Position Across The Board

Hey guys,

just after a bit of advice for my binding setup.

My bindings have 3 screw holes (like this: OOO) on each of the 4 mounting point to adjust where the binding sits across the board.

Question is, does setting the binding more on the heelside or toeside make any difference to the riding?

Mine was set up for me and on one binding the screws are mounted on the middle screw hole and the front binding it is on the heelside screw holes.

Toe and heel going over the board isn't a problem. Both protrude about 1cm but as they're angled they don't tend to be problematic ( +15 / -9 ). I could adjust to any of the 3 and be ok.

Just looking for the optimum setting and/or pros and cons of each config.

Advice much appreciated.
lucasdg is offline  
Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome