Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - Carving.
Thread: Carving.
View Single Post
Old 09-18-2012, 10:28 AM   #13 (permalink)
TLN
Senior Member
 
TLN's Avatar
 
Join Date: Sep 2010
Location: Kazachstan
Posts: 321
Default

Hey.

You're acting like i did couple of years ago =). Really.
So... the main board is bobmer online.

Check out videos here. I'm proud this was done by russian carvers =)

Then: Don't try to get this lay-downs on a softboot board.
Grab alpine snowboard. You can get this for $300-400 in nice conditions. I got mine in Kazachstan (that's waaaay far from any markets) for $400. It was Prior 4wd 179, regular cost $800.
Grab boots: You can buy new one for.. $500 =) or used for $100-200. I got mine 325s from UK for $80. They're in nice conditions and with liners from deeluxe 700.
And pair of nice binders. You can try to get a bomber td2 or f2 race ti for cheap. I wasn't adviced to but anything lower, as i'm quite huge guy =)))
Lower end binders go for $50. The one i named cost $150-200.

And.... That's really amazing. In my 1st day i can make a carved turns, no drift at all. pencil-wide path from me.
After 5-6 days i can go where i want to go and my board poped my ass from a frontside to backside.


After i tried to go same on my never summer legacy i noticed that i fall waaay earlier in a turn. This actualy ended in a custom and very wide Donek board.


so, forget about carving in a softies, grab a alpine board and check this out.
ps. those guys on video own a nice bunch of Kesslers and SG with plates, so they can even carve a plastic packet or wooden door

pps. drop me a message if you got any questions =)
TLN is offline   Reply With Quote