Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - automotive engineering SUCKS!!!!!
View Single Post
post #18 of (permalink) Old 10-06-2012, 01:15 AM
john doe
Veteran Member
john doe's Avatar
Join Date: Nov 2009
Location: St. Louis, MO
Posts: 1,410
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
One' of the worst designs I've seen was my uncle's 96 Honda Accord. To remove the front brake disk requires you to unbolt the CV shaft and remove the hub bearing assembly. Then put that in a clamp and unbolt the disk from the hub.

On my 95 Neon everything was cake. Even changed the fuel pump assembly with out dropping the tank. Well, everything but the heater core that required removing the entire dash assembly. The only weirdness was that the crank pulley is a 6 ton press fit and requires a special puller. It's carried by Autozone and free to rent.

The worst plugs I've ever done was on my friends 99 Caravan with the 3.0. The cowl comes halfway over the engine. You have to get to some from under the van.

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.

2011 Smokin Buck Ferton 155
2013 Flow NX2-SE
2013 Flow Hylite boa
Burton Stagger pants/jacket
Smith I/O

Last edited by john doe; 10-06-2012 at 01:18 AM.
john doe is offline  
Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome