Join Date: Jan 2010
Location: Milwaukee Suburbs
Mentioned: 0 Post(s)
Tagged: 1 Thread(s)
Quoted: 0 Post(s)
Can you rotate the disc 90 degrees so the holes are parallel to the base plate and still mate up to the holes in the board. If so you can then use the extra holes in the slot to slide the binding back a 1/4" to 1/2" and that may give you just enough overhang toe and heel.
Does that make sense?? Hope it helps.
Stole this pic off the web so yours would face like this **Parelllel **
because I think yours are like this NOW and not allowing you to slide them back a bit **Perpendicular **
-I'm Slyder and I suffer from "Gummer Syndrome"
Last edited by slyder; 11-11-2012 at 10:22 AM.