Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - DIY Splitboard Workshop
View Single Post
post #11 of (permalink) Old 11-16-2012, 08:33 PM
Veteran Member
walove's Avatar
Join Date: May 2009
Location: Bozeman/Seattle
Posts: 767
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Progression requires experimentation. I want to build diy boards with no tnuts. Tele bindings for years only had three screws per binding and people, but skis are beefed up in the mounting area. If I add another layer of glass where the touring bracket goes I think it will do the trick.

Side note, my first split snaped across the touring backet while skinning through a dip. The board had an "air core" where the core has channels milled out between the bindings not good for a split but I didn't know untill the board was cut. It lasted three years.

I built a dynafit soft boot this summer so a different hole patern is needed.

walove is offline  
Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome