Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - Bataleon 2012 Q & A
View Single Post
Old 11-17-2012, 02:00 AM   #717 (permalink)
Lester86
Member
 
Join Date: Feb 2012
Posts: 75
Default Bataleon Evil Twin Thread issues

So as I mentioned before I was planning on taking out my new Evil Twin tomorrow but my plans were quickly changed when I tried putting my bindings on for the first time on the board ... first off I'm not a newbie to installing bindings that said I was screwing on the bindings got all 4 screws on (loose) to start them off then started tightening them down lightly and 3 went on fine the last one I was trying to tighten and it was tight after about a 1/2 of turn. I stopped didn't put any pressure on the screw and tried to reverse it no luck couldn't move forward or backward it was seized on it felt.. Did anyone have this happen to them it obvious was happen it got cross thread but how is that possible if it started off fine then out of no where it's stuck. Any suggestions on how to avoid this because I'm honestly nervous to put bindings on the new one
Lester86 is offline   Reply With Quote