Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - my DIY swallow tail burton supermodel 172
View Single Post
Old 12-12-2012, 06:07 AM   #72 (permalink)
Senior Member
Sim79's Avatar
Join Date: Aug 2008
Location: Australia
Posts: 109

The thin layer of urethane worked a treat, looks a lot better now.

ETM I was going to put my bindings back far as possible again, but had a thought that this might be pointless now. I might have too much weight now on the rear off board and loose too much float.
Having the bindings central might balance the board out better?

Have you played around with binding postions since doing the chop?
Do you still run your bindings back as far as possible?

Last edited by Sim79; 12-12-2012 at 06:12 AM.
Sim79 is offline   Reply With Quote