From the looks of it, I think you should be able to clamp that no problem. As poutanen said, you should be able to use just about any general-purpose epoxy for a repair this small. A basic 2-part epoxy adhesive from a home improvement or auto parts store should be fine. It may not be an issue since the damage is fresh, but make sure the area is clean (ideally with acetone or MEK if you have it) and dry. Then mix the epoxy according to the directions and use a small disposable brush or spreader to coat both sides of the repair area. Clamp and let cure. Use enough to coat it but not so much it oozes everywhere. You might want to put wax paper between the topsheet and wood block or clamp just to ensure the clamp or block doesn't stick to the topsheet from any excess epoxy.
Last edited by herzogone; 12-23-2012 at 03:33 PM.