Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - DIY board Gopro mount
View Single Post
post #1 of (permalink) Old 02-07-2013, 06:41 PM Thread Starter
Senior Member
Joe77's Avatar
Join Date: Feb 2013
Location: Nor CA
Posts: 121
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 1 Post(s)
DIY board Gopro mount

This is just my second post and i hope this is in the right sub-forum.

My DIY addiction relapse kicked in again today. Since I already have everything i needed, why not specially after hearing that nothing out there works well when mounting a Gopro to the board. The 3M sticky pad was removed, the bottom surface of the mount was contoured to follow the boards nose bend, stainless steel bolt with very low profile aluminum t-nut. I used Locktite Repair Extreme to glue the mount and also inside the drill hole and around the bolt/nut flanges before everything were mated. The glue dries waterproof and withstands vibration and freezing temps which even has look and flexibility of p-tex. I still need to get a few drops of wax around the t-bolts just for extra measure.

Joe77 is offline  
Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome