Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - Damn it alive!!!!!
View Single Post
post #23 of (permalink) Old 02-11-2013, 01:46 PM Thread Starter
Joe Coffee
Senior Member
 
Joe Coffee's Avatar
 
Join Date: Dec 2012
Location: Alberta, Canada
Posts: 130
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Ok apparently I am doing something wrong because no one has had this problem. I can't find anyone on the internet having this problem and guys in skate shops said they have never seen the problem before. So here is what I am doing. Maybe you guys can point out something wrong I am doing.


Step 1: I put the M6 sliders in the channel.

Step 2: I put the binding on the board and put the two sliders up through corresponding holes on the disc. (Meaning both inserts are in hole 2 or hole 3 etc)

Step 3: I use a number 2 phillips screwdriver (Does a number 3 tighten better?) to tighten 13mm burton screws and union washers. I Tighten till I can not tighten them anymore.

I have been thinking maybe the problem is as simple as not having them tight enough? Does a number 3 screwdriver work better other than fit better in the screw?

Current Setup
Burton Super Hero 2013 151cm, Union Force Bindings 2013, Burton Hail Boots.
Joe Coffee is offline  
 
 
Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome