Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - Damn it alive!!!!!
View Single Post
post #30 of (permalink) Old 02-12-2013, 10:08 AM Thread Starter
Joe Coffee
Senior Member
Joe Coffee's Avatar
Join Date: Dec 2012
Location: Alberta, Canada
Posts: 130
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Originally Posted by Cyfer View Post
It's been a while since I worked in a shop so I hope my information isn't too out of date. Use the 13 mm screws, they need to be shorter since the mounting hardware is not recessed into the boards top sheet. I would suspect your discs here, unless you base plates are warped. What I would try is simple, and cost you a lot less than new bindings. New discs and hardware first. You should be able to get everything you need with two phone calls, one to C3 and the other to Burton. I wouldn't be surprised for free. Try replacing all your hardware M6 sliders and bolts as well (due to heavy tightening something could be bent slightly) and the discs, before dumping two or three bills on new bindings. What do you have to lose by trying that, 10 bucks or so?

Don't cut off the head to stop the headache first. Try the cheap route, if it still is screwed up then I would replace your bindings because your baseplates might be warped causing play when the board flexes. Hope it's just the discs, good luck.
Yeah I went and got new hardware from burton and discs from union. I also have a disc from burton on the way. I am going to install the news discs and put some padding underneath the binding and tighten the screws well with a #3 screwdriver. It should work this time around. If not I am going to nuke down a hill into a tree. (Or maybe I should call union and ask for a new pair of bindings in the event these ones are warped?)

Current Setup
Burton Super Hero 2013 151cm, Union Force Bindings 2013, Burton Hail Boots.
Joe Coffee is offline  
Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome