Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - Does this edge need to be re-repaired?
View Single Post
Old 02-13-2013, 11:43 AM   #4 (permalink)
bcoon
Junior Member
 
Join Date: Feb 2013
Posts: 16
Default

Quote:
Originally Posted by timmytard View Post
Well, it's pretty fuckin' ugly, but it didn't look to bad.

Does it look like water will get in there?

If it does, I would just get a little epoxy & force it in there.

A hair dryer works good to make it flow easier.
I like to use a sanded flat bamboo skewer like a spatula.

Or just drip some p-tex into it.


I wouldn't waste money getting it fixed, it's pretty easy to do yourself.


TT
Yea.. pretty ugly up close w/ the pics but not as bad in person. I'm not sure if you can really make it out, but there is a small crack running down the center of the epoxy (or whatever that is) that's in there. All I'm really worried about is water getting in there. The edge does flex a bit right there if I press hard though, assuming because of the crack. Any suggestions for a specific type of epoxy for this?
bcoon is offline   Reply With Quote