Can someone help me out with this?
Not sure what angle to sent the multi angle tool to for my Raygun.
Haha.... looks like we got almost the exact same kit.
If you have a 3* base bevel then set your tool to 3*, but ONLY to clean up any burrs on the base edge. From the reading I've done a gummi stone may be all that is needed on your base, but using your new green diamond stone with light pressure after a side sharpening can't hurt.
I didn't see you list your side bevel, which is the one you'll really want to find out. You won't use the file unless the edge is fucked up or you want to change the bevel angle. However, you will want to set your tool to the proper side bevel angle so you can use those diamond stones properly. You need to know the boards side bevel angle before you can properly setup the tool.