Snowboarding Forum - Snowboard Enthusiast Forums - View Single Post - My DIY splitboard project
View Single Post
post #8 of (permalink) Old 06-24-2013, 02:31 PM Thread Starter
West Baden Iron
West Baden Iron's Avatar
Join Date: Jan 2013
Location: West Baden Springs, IN
Posts: 341
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Well, I stopped being a dumbass on the printable templates and just measured them. The pivoting hook holes are exactly 0.75" and the tail clip holes are exactly 1.00". So I believe that they are to the correct scale as I printed the pattern for the holes for using the universal pucks from with the measurements on them and they came out correct as well.

One more question, what is the standard dimension for the width between the holes on a standard split board? The patterns I found have 2 options, 3.34" and 3.375". I have researched, but obviously I'm not searching correctly because I cannot find this dimension. I realize the difference is minimal at 0.025", but I want to get it right if I do go this route.

West Baden Iron is offline  
Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome