Buttering - Snowboarding Forum - Snowboard Enthusiast Forums
SnowboardingForum.com is the premier Forum on the internet. Registered Users do not see the above ads.
Reply
 
LinkBack Thread Tools Display Modes
Old 12-18-2013, 05:36 PM   #1 (permalink)
Junior Member
 
Join Date: Dec 2013
Posts: 2
Default Buttering

Wondering which is more ideal/optimal for binding screw/hole position for buttering.

1) Screw holes closest to both ends of the board
2) Middle screw holes
3) Screw holes closest to centre of the board

Thanks!
cyclogenisis is offline   Reply With Quote
Sponsored Links
Advertisement
 
Old 12-18-2013, 06:44 PM   #2 (permalink)
Veteran Member
 
Mystery2many's Avatar
 
Join Date: Aug 2013
Location: Atlanta ga
Posts: 1,097
Default

Less tip and tail is less board to support your press. But reality is a comfortable stance is most important. Butters is all about technique not binding posotion unless your rocking a crazy carve stance.
Mystery2many is offline   Reply With Quote
Old 12-19-2013, 03:20 AM   #3 (permalink)
Member
 
afuciarelli49's Avatar
 
Join Date: Oct 2013
Location: Michigan
Posts: 53
Default

i have my bindings should length apart. with even space from my bindings to the tips on both ends.

also roll with a not quite 15 15 stance
afuciarelli49 is offline   Reply With Quote
Old 12-19-2013, 03:47 AM   #4 (permalink)
Member
 
Join Date: Dec 2013
Posts: 31
Default

I guess it would depend on how stiff the board is and where you prefer your center of balance to be...

I usually go +1 or 2" of shoulder width, but you could have really wide or narrow shoulders so it's hard to say
KillinIT is offline   Reply With Quote
Old 12-19-2013, 05:45 AM   #5 (permalink)
Member
 
Join Date: Dec 2013
Posts: 67
Default

The wider your stance is, the easier it is to lift your nose or tail on the ground. So if you are able to ride normally with your bindings in the biggest stance possible, you will be able to butter very easily. However, butters are more about your balance. So with a good balance you can do butters, no matter where the bindings are. First you just have to find the limits of the board, how far you can lean before falling etc.
Rasse is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -5. The time now is 12:37 AM.



Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0 PL2
VerticalSports
Baseball Forum Golf Forum Boxing Forum Snowmobile Forum
Basketball Forum Soccer Forum MMA Forum PWC Forum
Football Forum Cricket Forum Wrestling Forum ATV Forum
Hockey Forum Volleyball Forum Paintball Forum Snowboarding Forum
Tennis Forum Rugby Forums Lacrosse Forum Skiing Forums