Hey all,
Just got a new pair of Union Force bindings (L/XL) and a new Never Summer Proto HDX.
When mounting the Forces to the Proto, I noticed the mounting screws are really short! I couldn't even get them started with the washers on. I had to screw one hole in with no washer, to compress the binding cushioning, and then I could get the other three in with washers, and then back out the original one, put a washer on it, and put it back in.
There is no way there is very much thread engagement at all. I am worried I am going to rip the threaded insert out of the board at some point.
Is this normal? Any suggestions?
Thanks.
Just got a new pair of Union Force bindings (L/XL) and a new Never Summer Proto HDX.
When mounting the Forces to the Proto, I noticed the mounting screws are really short! I couldn't even get them started with the washers on. I had to screw one hole in with no washer, to compress the binding cushioning, and then I could get the other three in with washers, and then back out the original one, put a washer on it, and put it back in.
There is no way there is very much thread engagement at all. I am worried I am going to rip the threaded insert out of the board at some point.
Is this normal? Any suggestions?
Thanks.