Snowboarding Forum - Snowboard Enthusiast Forums banner

Flow NXT-AT cable replacement

9K views 6 replies 5 participants last post by  Allen Chen 
#1 ·
Hello, can you guys point me to the right direction on purchasing a replacement cable for my beloved 2012 NXT-AT (Large, if it matters), the cable snapped mid mountain on my last run of the day, fortunately. I have contacted FLOW on the official site and they are asking 49.99 plus shipping for one cable. I wonder if NX2-AT use the same cable and i can just ask for that instead.

One of my toe side buckle screw also went missing (the assembly that connects the buckle to the binding), thankfully the pro shop was able to rig something to hold it in place.

Cheers from NYC
 
#2 ·
they should have them at most repair shops for snowboards, especially ones attached to a flow sales place....

The guys at Crystal had a full kit with everything needed for bindings an boots, they didn't even carry flow products... They gave us the boa cable for free that we needed....
 
#4 ·
Went to Paragon (they carry flow) and was told that they can't help me with it since the bindings are too old. They also went on with the "you dont let your friends ride flow" mantra. The rep was nice enough to suggest on trying to get a ball end cable crimp and a separate steel cable wire, since they are pretty much pennies compare to order from Flow.

That, or i get a new pair of bindings...
 
#7 ·
the argument is most people still buckle down after flipping up the highback, which defeat the purpose of having flow. Personally, i just kick my boots in and clip in the high back as i skate down the unloading area so my skier friends never had to wait. Yes, the flow may not respond as snappy as the regular since the cable will stretch as you lean onto them which made the board feel wider than it is but my butt is never cold from constantly sitting down (as a novice)

Anyways, we drove 100 miles to BlueMountain in PA which they had the cables from old rentals however they were too short. (if you are looking for flow parts and cant find any, call blue.)

time to find a new pair of binding to go with Proto CT.

suggestions?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top