Flux bindings on a Burton board? - Snowboarding Forum - Snowboard Enthusiast Forums
User Tag List

LinkBack Thread Tools Display Modes
post #1 of 2 (permalink) Old 01-24-2010, 11:57 PM Thread Starter
Join Date: Nov 2009
Location: Perth, Australia
Posts: 46
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
Flux bindings on a Burton board?

Has anyone had issues with fitting their flux bindings onto a burton board before? My '09 Flux Super Titans arrived today, and I immediatelly tried to fit them onto my '09 Burton Mayhem. Problem was that the holes weren't lining up with the baseplate on the 4 x 4 set-up, so I then tried to use the Burton 3 screw set-up, but again, the holes didn't line up!

Reading the Flux instructions (which aren't overly helpful) it says that the binding should fit onto any 4 x 4 set-up. So I measured the dimensions of the holes on my board, and its more of a 4 x 4.5cm set-up.

Anyone have any similar issues or possible resolutions?
saudade101 is offline  
Sponsored Links
post #2 of 2 (permalink) Old 01-25-2010, 12:09 AM
Senior Member
Reede's Avatar
Join Date: Feb 2009
Posts: 398
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
You need the 3 screw baseplate to fit that board, and make sure you have the little washers in the baseplate all in the same position, if one of them is in a different spot relative to the others then it wont line up properly, make sure they are all centred within their own little groove.
Reede is offline  

Quick Reply

Register Now

In order to be able to post messages on the Snowboarding Forum - Snowboard Enthusiast Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome