Binding Width question - Snowboarding Forum

Serg25 · 09-07-2010, 08:42 PM

I just bought a NS Revolver. I set up my bindings at a 23 inch width but I want to go to 24. I noticed that if I want to go to 24 inches I would have to have a setback. Is there any way to have a centered stance?

And is there anyway to have 23 1/2 inch width?

legallyillegal · 09-07-2010, 10:15 PM

rotate the discs so that the holes run parallel to your board's edges

Serg25 · 09-08-2010, 01:38 PM

its pretty hard to read the binding angle like that. I had to guess

JeffreyCH · 09-08-2010, 02:03 PM

I did that with my (Ride)shift disc's and the binding angles are marked for either way.

Serg25 · 09-08-2010, 02:08 PM

I have Burton Cobrasharks and they dont have the markings when you put them parallel. I ended up counting the number of clicks.

Serg25 · 09-18-2010, 08:38 AM

Do you think if I call Burton, they'll send me a different disk that fits when putting in the disk holes parallel to the boards edge.

09-07-2010, 08:42 PM	#1 (permalink)
Serg25 Member Join Date: Jan 2010 Location: Maine Posts: 79	Binding Width question I just bought a NS Revolver. I set up my bindings at a 23 inch width but I want to go to 24. I noticed that if I want to go to 24 inches I would have to have a setback. Is there any way to have a centered stance? And is there anyway to have 23 1/2 inch width?

09-07-2010, 10:15 PM	#2 (permalink)
legallyillegal -LIFETIME MEMBER- Join Date: Oct 2008 Location: fuck Snowboarding Posts: 4,446	rotate the discs so that the holes run parallel to your board's edges __________________ THERE ARE SPECIFIC REASONS AS TO WHY I AM MORE LOCAL THAN YOU GOD IS DONUT

09-08-2010, 02:03 PM	#4 (permalink)
JeffreyCH -LIFETIME MEMBER- Join Date: Nov 2009 Posts: 1,492	I did that with my (Ride)shift disc's and the binding angles are marked for either way. __________________

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-08-2010, 01:38 PM	#3 (permalink)
Serg25 Member Join Date: Jan 2010 Location: Maine Posts: 79	its pretty hard to read the binding angle like that. I had to guess

09-08-2010, 02:08 PM	#5 (permalink)
Serg25 Member Join Date: Jan 2010 Location: Maine Posts: 79	I have Burton Cobrasharks and they dont have the markings when you put them parallel. I ended up counting the number of clicks.

09-18-2010, 08:38 AM	#6 (permalink)
Serg25 Member Join Date: Jan 2010 Location: Maine Posts: 79	Do you think if I call Burton, they'll send me a different disk that fits when putting in the disk holes parallel to the boards edge.