is binding mounting hardware universal? - Snowboarding Forum

beans112 · 10-20-2010, 05:36 PM

so I bought a pair of M3 vortex bindings off of amazon but they didnt come with any mounting hardware so i was wondering if all mounting hardware was universal I'm putting them on a heelside snowboard. so would 6mm x 14mm screws work? and can you please tell me where i could order some. no local shops have them in yet and home depot doesnt have the washers.

Puggy · 10-20-2010, 06:11 PM

Basically 3 different set ups. 2 unique to just burton and 1 is the one you gotta worry about. There's ICS which is Burton's "Channel Tech" and Burton's 3D bolt set up. Since you aren't riding Burton everything else is 4x4 and take the exact same screws. Would not go to home depot though to get screws unless you are 100% positive that the thread depth and size is the exact same. As soon as you start stripping the inside of the board out, you're effed, and you don't want your bindings popping out of the board mid run.

10-20-2010, 05:36 PM	#1 (permalink)
beans112 Junior Member Join Date: Oct 2010 Posts: 2	is binding mounting hardware universal? so I bought a pair of M3 vortex bindings off of amazon but they didnt come with any mounting hardware so i was wondering if all mounting hardware was universal I'm putting them on a heelside snowboard. so would 6mm x 14mm screws work? and can you please tell me where i could order some. no local shops have them in yet and home depot doesnt have the washers.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

10-20-2010, 06:11 PM	#2 (permalink)
Puggy Senior Member Join Date: Oct 2010 Location: Ontario, Canada Posts: 204	Basically 3 different set ups. 2 unique to just burton and 1 is the one you gotta worry about. There's ICS which is Burton's "Channel Tech" and Burton's 3D bolt set up. Since you aren't riding Burton everything else is 4x4 and take the exact same screws. Would not go to home depot though to get screws unless you are 100% positive that the thread depth and size is the exact same. As soon as you start stripping the inside of the board out, you're effed, and you don't want your bindings popping out of the board mid run.