Screw size for Rome Targa footbed - Snowboarding Forum

DrnknZag · 11-24-2010, 08:19 PM

I got a set of Rome Targas for my NS SL, but can't figure out what I did with the two screws that secure the canted footbeds to the mounting disk. What size screws can be used? I'd rather not take the bindings off the board at this point, otherwise I'd just take the mounting disk to the hardware store and figure it out....

ev13wt · 11-25-2010, 04:48 AM

Just email them quick like, you will have an answer just as fast. Awesome customer relations at that place. I think its metric 4mm. But please don't take my word for it. I could measure it for you tomorrow no problem. You could always go into a hardware store/automotive store and take a disk with you.

Why not take of the bindings?

11-24-2010, 08:19 PM	#1 (permalink)
DrnknZag Veteran Member Join Date: Feb 2010 Location: PNW Posts: 922	Screw size for Rome Targa footbed I got a set of Rome Targas for my NS SL, but can't figure out what I did with the two screws that secure the canted footbeds to the mounting disk. What size screws can be used? I'd rather not take the bindings off the board at this point, otherwise I'd just take the mounting disk to the hardware store and figure it out....

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-25-2010, 04:48 AM	#2 (permalink)
ev13wt Senior Member Join Date: Nov 2010 Posts: 446	Just email them quick like, you will have an answer just as fast. Awesome customer relations at that place. I think its metric 4mm. But please don't take my word for it. I could measure it for you tomorrow no problem. You could always go into a hardware store/automotive store and take a disk with you. Why not take of the bindings?