Binding Setup, help
Alright, So I just got back from the shop with my new board. I ripped off my old bindings off my old board and I'm trying to fit them properly to my new one. I'm trying to set up a Front = +15 and back = -3 just to try it out for now and I'll adjust later. The only problem is I'm trying to center my bindings so I have equal hangover from boots on each side. The front binding is perfect, but the back binding when I have it centered, the front of the binding hangs over by about half an inch, and I can't seem to adjust that right to get it flush with good angles. When I do get it flushed by off centering a bit, the back of my boot hangs over way to much and is not a equal distance of front/back hangover. Any suggestions please? This will be my last ride with my old binding until my new ones arrive.
- mid 2000 Mission binding
- 2010 Burton Operator with channel
Never mind, figured it out... "Close Thread"
|All times are GMT -5. The time now is 11:59 AM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.