I had some issues with my ratchets on my m9s and flow sent me some new ones but i can't figure out how to put them on. Where the screw goes is covered up by the teeth and i don't know how im going to get a screw driver in there to tighten it.
If pics are needed i will post. Thanks in advance.
Hey I changed mine out on my old Team Bindings. I had to drill the rivets out.My screw kit didn't come with the barbed nut thing.The kit that I had the screw went in on the inside of the power strap and the threaded piece went in the hole in the ratchet.I would post pics but I no longer have the bindings,you can also call Flow up ask for Cristian not sure if I spelled his name right.
I looked at your pics again can you flip the ratchet in a way to put the screw in? or you can get the screw in but can't fit a screwdriver in to tighten the screw tight? I remember it being a pain in the ass to switch mine out maybe you have to hold your mouth right to do it.:laugh:
I looked at my NXT ratchets to see how you would screw the screw in from the top of the ratchet.I don't see how it could be done unless you had some kind of custom screw driver.
ya i know you can get flex bits for drills but i don't think they would bend into that tight a space. Im going to give it a try and talk to flow. If i can't get it i will just pick up some bindings for cheap, everything is on sale right now anyway.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Snowboarding Forum - Snowboard Enthusiast Forums
1M posts
46.5K members
Since 2006
A forum community dedicated to all Snowboarding enthusiasts. Come join the discussion about equipment reviews, tips, traveling, gear troubleshooting, share photos, and more!