I need to mount by 2010 union force bindings on my new 2010 Burton jeremy jones Snowboard with channel.
The guy who sold me the board (220 bucks new, great deal) told me i would be able too.
How do i do it?
I asked union and there reply was two words by email "You Cant".
Burton replied saying that it is probably best to contact union but if that fails they will send me whatever they have that might work. Basically burton Gets an A+++ and i am not a burton lover. I hate the fact that they try to make everything as proprietary as posbble and i hate their prices but their customer service is Top notch.
Using the m6 disk with standard m5 hardware things were looking great.
But, The screws end up coming higher than they would normally and its making the gas pedal come in contact with the screws and less of the base plate. the screws have little washers on them im trying to get rid of. That will fix it i think.
If i cant do you guys think the screws pushing the Gas pedal up make a big difference.
I cut off the washers on the screws.
Now the problem is not nearly as bad but the screws are still poking up about 4 mm. Do you think this is a problem? Im going to strap in and see how it feels.
I think im going to also try getting my hands on a union conversion disc.
Edit: I now realize what i am doing is pretty much what ETM recommended so thanks etm.
I strapped in and it felt totally fine.
Should i buy the 15 dollar union plates? Its funny cus even though burton trys to gauge you, all the extras such as j bars, Plates, screws and everything will be sent to you and you dont even have to pay for shipping.