Your wife's board is perfect. And personally from what I've seen on your board id roll with it. My boot hangs off the back of my bindings and the front of my bindings way more than that and I experience zero toe drag or heel drag.
It comes and it goes. Get it while it Lasts. To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
If I was to try and centre my boot on the board, the binding would have to move. And that would make them hang over the toe edge.
you cant just move the heel cup?
my union force I can move the heel cup without moving the base.
looks like you could. these screws near the base by your heels, they are there so the high back and heel cup would move in and out for different boot sizes.
Last edited by speedjason; 12-23-2013 at 03:23 PM.
that looks fine froot, dont sweat it. You live and you learn. Burton bindings are not super adjustable due to the unibody design. You can tune it to within a 1/2 CM or so and live with it at that point. If you are concerned about the front of the basepad extending past the edge the that can be moved in slightly but it looks like it is fairly far back on yours.
Last edited by cav0011; 12-23-2013 at 08:02 PM.
Reason: read back some.
yeah the base pad is set all the way back, so there is no room for it to go back further.
Thats as short as i can get the binding.
If i undo the screws for high back and push them all the forward, is that what there for? or is that to get the high back parallel to the board?
Last edited by FrootStick; 12-23-2013 at 11:03 PM.