Burton Board/Bindings issue
 

So my sister just got a new Burton board and we were going to throw some flow bindings on it. Ends up the patterns wouldn't match. Same thing with a pair of Ride bindings. Would you have to buy a different plate to put in the bindings? Burton has the different patters where as most others have the 2 vertical lines.

You only need 3 screws would any of these work? I don't know what hole pattern you have so can't say. Most new bindings come with a universal mounting plate, if they're older you might have to buy new plates.

http://www.alpinecarving.com/3d.gif

Oh my I think I tried everything except the TD1 4 pos. Haha it's like a revelation to see this chart, Thanks again Jenzo.

heres another thread with same question

http://www.snowboardingforum.com/gen...ton-board.html

Oh wait I was wrong, The bindings she was going to use were Flows which seem to be the topic of that discussion also. They were only going to be temporary until she got a new pair, she'll be okay using her K2 this weekend lol