Repair Gouge in top
I have a couple spots on the top edge of my board, above the metal. that have some small gouges- not exactly sure, but one might go past the top layer of plastic. None are more than half an inch long.
There are also some other spots with tiny nicks, and I would like to fill them so that water does not creep into the spaces.
I have searched and I find several techniques for the bottom, but is it safe to just fill the top gouges with superglue or something similar? I have seen superglue dissolve some materials, so I am just checking if this is okay.
If not, what product can I use for small gouges like this?
Thanks in advance