Snowboarding Forum - Snowboard Enthusiast Forums

Snowboarding Forum - Snowboard Enthusiast Forums (http://www.snowboardingforum.com/forum.php)
-   Boards (http://www.snowboardingforum.com/boards/)
-   -   Quick question about new board (http://www.snowboardingforum.com/boards/121585-quick-question-about-new-board.html)

iamstig 01-21-2014 08:13 PM

Quick question about new board
 
I've been riding a Burton Twin 157 for a couple of years and liked it a lot. I wanted to try new bindings though and found I couldn't use the ones I wanted on the old M5 ICS board so I sold it and am now trying to figure out which new board I want. I have narrowed it down to a Rossignol Angus or Taipan as both are on sale locally and they seem like great boards. I ride mostly groomers on prairie bumps so our runs aren't typically long, steep or powdery so I've now taken to trying a few simple jibs etc. I don't see me being a park rat though...far to old to start that :) I do kite board though so the twin shape is a must.

Anyway I'm 5' 11", 165 - 170lbs and have Burton Moto 11.5 boots. Most manufacture sites seem to claim that I'd need a wide board but my Burton wasn't that wide (254mm) and I never had an issue on that.

The shop has an Angus 155 (250 waist) and a 158 MW that's listed at 261 waist and I think the Taipans are similar widths. I haven't ridden a true wide board in years when I was just learning and when I switched to the Burton Twin I notice how much better it felt. When I put the 155 next to the 158MW and stood on both the 158MW seemed so much bigger so I'm having a hard time deciding if I should go for a longer wider board or not?

Thoughts?

iamstig 01-25-2014 02:19 PM

I ended up buying a 158mw Taipan instead. Tip to tip the 158 Taipan was 1cm shorter than the 158 Angus and when I did the bare foot test the MW gave me a better fit width wise.


All times are GMT -5. The time now is 01:05 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0 PL2