I wanna rotate my highbacks on some Ride Spi's.
When I remove the "hinge bolts" on the highbacks, I see that they're both in the middle of 3 possible positions. Simple, I think. I'll put right side one of the in the forward postion and leave the left one in the middle. That should rotate it clockwise.
When I do that, the highback rubs and the forward lean adjuster never gets to within 1/2 inch of the rail it's supposed to rest on.
Okay, so I put the left one in the rear position (pulling that side forward) and put the right back into the middle position. Same amount and direction of rotation, but now the FLAD completely misses the rail and slides down in front of it.
Obviously, I missing the idea here somewhere. Any ideas?