Yeah sorry I typed that out a little vague. You want equal parts of the heel and toe of the boot hanging off the edge on the bindings, so if you have 1/2 inch of heel hanging off the back you want 1/2 inch hanging off the front.
Hope that is a little more clear but I am sure someone else will chime in with a more detailed answer.
Looks better but maybe still too much to the heel side. Kind of hard to tell from these photos...try to get down flush with the deck and right down the centerline of the board like the photo I attached. It will be easier to see there.
In case your still having trouble, the slots on the baseplate should be going toe to heel side, put in the screws but don't tighten them, do up your boots tight and strap them in, CENTER THE BOOT and take a look from whichever angle either head on or base, slide binding forward or back and look again to make sure the boot is centered, tighten screws all the way when you got the boot centered.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Snowboarding Forum - Snowboard Enthusiast Forums
1M posts
46.5K members
Since 2006
A forum community dedicated to all Snowboarding enthusiasts. Come join the discussion about equipment reviews, tips, traveling, gear troubleshooting, share photos, and more!