Snowboarding Forum - Snowboard Enthusiast Forums banner

Is this set up correctly? Beginner here

2K views 14 replies 9 participants last post by  freshy 
#1 · (Edited)
I tried to make it dead center i felt like it is a bit too much on the heel side, is it?

I ride goofy:






 
See less See more
4
#4 ·
Yeah sorry I typed that out a little vague. You want equal parts of the heel and toe of the boot hanging off the edge on the bindings, so if you have 1/2 inch of heel hanging off the back you want 1/2 inch hanging off the front.

Hope that is a little more clear but I am sure someone else will chime in with a more detailed answer.
 
#11 ·
might be easier to tell if you look at the overhang from the bottom of the board. that's what i do.
 
#15 ·
In case your still having trouble, the slots on the baseplate should be going toe to heel side, put in the screws but don't tighten them, do up your boots tight and strap them in, CENTER THE BOOT and take a look from whichever angle either head on or base, slide binding forward or back and look again to make sure the boot is centered, tighten screws all the way when you got the boot centered.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top