edges be trippin
 

http://i49.tinypic.com/28u60it.jpg
hey my dumbass did this in the park the other day
what can I do to fix it and if I don't what will happen?

You want the ghetto fix or the real fix?

put it between 2 piece of metal and smash it with a hammer till its more flat than that and then cover the whole thing in shoo goo.

I would just have gone with the "deliver it to the local snowboard shop technique", who usally knows what to do. Either they can do it for a small fee, or can give you some "to-do", and not "to-do".

- P

get a new board

do me up with a ghetto fix so I can go shred tomorrow

if only your board didnt have edge wrapped around the tip and tail...

Slap duct tape over it. Or put some 2 part epoxy on it then slap duct tape over it.

Yes WAlove cause a tucked edge is so superior. Have fun blowing contact points out.

Take a c-clamp to it

I think you'd be better off just leaving it alone, start messing with it and your ptex/topsheet will separate. It's going to hurt anything, if you have any expose fiberglass gore, maybe squirt a little super glue on it.