Binding Setup - Snowboarding Forum - Snowboard Enthusiast Forums is the premier Forum on the internet. Registered Users do not see the above ads.
LinkBack Thread Tools Display Modes
Old 08-07-2007, 04:04 PM   #1 (permalink)
Posts: n/a
Question Binding Setup

My current board has a 1 inch stance setback, so I decided to move my front and back bindings up to make the stance centered (its a burton board & bindings so I'm using the 3-D screw setup). When I did this though, I end up having 1 screw hole fully exposed behind each binding. I'm wondering if this is safe for the board. If water gets in the screw hole will it rust, because I may want to switch the stance back. Also, to be safe I could just put an extra screw or some surf wax or something in those holes (but not thru the baseplate) so they are protected from snow/ice/water. Someone help me
  Reply With Quote
Sponsored Links
Old 08-07-2007, 05:06 PM   #2 (permalink)
Posts: n/a

Just leave them alone, they'll be fine. Water will get in the vacant screw holes anyway, even if they're covered.
  Reply With Quote
Old 08-07-2007, 11:55 PM   #3 (permalink)
Posts: n/a

agreed. nothing on a board is staying dry. it aint made of metal though. either wood or synthetic core. just keep the edges clean and the base waxed.
  Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

All times are GMT -5. The time now is 06:00 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0 PL2
Baseball Forum Golf Forum Boxing Forum Snowmobile Forum
Basketball Forum Soccer Forum MMA Forum PWC Forum
Football Forum Cricket Forum Wrestling Forum ATV Forum
Hockey Forum Volleyball Forum Paintball Forum Snowboarding Forum
Tennis Forum Rugby Forums Lacrosse Forum Skiing Forums