[alexkarim]

Now im not sure if im in the right section for this but i have a question about installing my base plate into my board. I have burton cartel's with burton base plate and im trying to fit it into a k2 zepplin. The base plate has the 3 screws and are adjustable. My question is, how do I adjust the screws on the actual base plate to make the screws wider or narrower.

Thanks,

Alex

[Snowolf]

The Burton system uses the 3 hole pattern while all the rest use the 4 hole. It is my understanding that Burton bindings come with both disks. Did you get these used? If you do not have the standard disks, you may need to get them from a Burton dealer.

[megladan]

alex karim, if need em, i can send you some burton 4x4 baseplates..

[alexkarim]

Yeah i got them used. They came with the 3 holes and not the 4x4's.

How much for the base plates? Im going to bear tomorrow, do you think i can rent some?

[berg]

not sure if you can rent some...but i'm sure you can go to your local shop, or the resort shop and pick some up.

[alexkarim]

Thanks,
I actually just did that. CBS boardshop. That place kills.

[Grimdog]

Why wouldn't you just buy them you cheap bastards.

[tboooe]

Originally Posted by alexkarim

Yeah i got them used. They came with the 3 holes and not the 4x4's.

How much for the base plates? Im going to bear tomorrow, do you think i can rent some?

You may want to check the Bear website. Only chair 9 is open now. You will may want to go to Summit. I was going to go to Bear but will be going to Summit instead on Sunday.