|Topic Review (Newest First)|
|02-10-2014 08:18 PM|
If you want the cheaper side
It's a good kit to start with. If you want to go pro... Then start buying all the file guides over time
P.S. If the edges angles have never been altered.... then contact the board company and ask. If a shop has done edge tuning the last time around... I would ask them.
It wouldn't surprise me if it's 1°/1°
|02-10-2014 07:57 PM|
SwixSport.com : SwixProduct / File Holders TA288 File guide, racing, 2°
A friend of mine warned me that it takes about $400 to get all the stuff you need for tuning.
I didn't believe him but by the time you buy all of the stuff it adds up to that. File guides, diamond stones, vises, iron, etc. cost a lot. It pays for itself over time, and I keep my stuff sharp. With 7 boards in the family it doesn't take long to pay back.
It is much less stressful if you have an old rock board that you can mess around on first.
|02-10-2014 07:01 PM|
I read throught that entire Carvers Almanac and now I want to buy like $1,000 worth of tune up equipment and a few crappy craigs list boards to dice up and practice on! It's going to be a long summer after all.
Thanks for that link. That was supremely helpful.
|02-09-2014 08:36 PM|
Originally Posted by Lamps View Post
Thanks for the link too, I will check it out.
|02-09-2014 08:26 PM|
Originally Posted by TyBardy View Post
also note that you don't have to use the builder setup, you may want to add more or less, depending on your preferences.
more degrees = more edge hold, but will catch edges more - this is an oversimplification, the real answer is below.
Tuning - The Carver's Almanac
this article is very comprehensive.
lots of youtube videos on how to sharpen.
personally I recommend a proper metal file guide as opposed to those plastic ones that hold a little tiny square piece of file.
|02-09-2014 08:21 PM|
|TyBardy||yes, but I guess my question is... how do I know what the factory setup on the edge to begin with, and how do I know what each degree is going to "do" for me?|
|02-09-2014 08:18 PM|
|zk0ot||Buy a degree guide. 1 - 3 degree depending on how you want your edges|
|02-09-2014 08:16 PM|
how to tune my own edges
How do I tune my own edges? How do I know the correct angle to use when tuning my edges?
I am agraid of damaging my edges by doing this myself but I am very handy so I am sure I will be just fine once I know the proper method.