|Topic Review (Newest First)|
|03-08-2014 05:32 PM|
|Tourn||Cheers guys, got it all setup good, just hope I like the ride.|
|03-08-2014 04:58 PM|
This should help you out man.
How to Set Up a Snowboard - YouTube
|03-08-2014 03:55 PM|
|Tourn||So it wont strip the threads on the snowboard?|
|03-08-2014 03:35 PM|
the reflex binding disc arrow is off to the side. Look for it.
when you tighten , once it gets tight then do the other ones and then turn each one 1/4 of a turn rotating the each screw so they tighen at the same time. Basically dont just tighen one real tight and goto the next one and do the same thing. you will cross thread the screw.
|03-08-2014 03:32 PM|
|hardasacatshead||That's a bit of thread lock, it's meant to be there. It stops the screws from vibrating out once they're in. Crank 'em buddy, you'll be alright.|
|03-08-2014 03:23 PM|
I looked again at the screws and they seem to have a kind of blue plastic on them that makes the size bigger?
|03-08-2014 02:57 PM|
|West Baden Iron||
Originally Posted by Tourn View Post
Every tick on the disc is 3 degrees so you will be one tick from the 18 degree mark toward the 9 degree mark.
The screws should not get tight until they bottom out if you install them without the bindings. Make sure you are not cross threading them. You should be able to install them with very little pressure. Try a different hole and a different screw to make sure the threads aren't boogered on one of them. Inspect the screws to verify the threads are clean and uniform.
When you have the bindings installed, the screws engage about 2 or 3 threads before they start getting tight. To see if it is getting tight correctly, the bindings should start to get harder to move around. If the screw is getting tight but the bindings are still loose, then it has been cross threaded or may have a spot on the screw that you can file clean.
|03-08-2014 02:43 PM|
Setting up snowboard problems, need help!
Today I bought a rome reverb rocker 155w and burton custom bindings L.
I'm trying to set them up but am having some difficulty, I've heard a 15/15 stance is good because I jib frequently, but on my bindings there is no mark for 15 so I don't know what to do?:
Also when I was trying to install the bindings I put the screws in and did a couple of turns and found that it got very tight so I took them out to avoid threading. This is how much I can screw it in before it gets tight:
I don't know what to do, I don't want to screw my board?
Any help will be appreciated, thanks.