Snowboarding Forum - Snowboard Enthusiast Forums - Reply to Topic
Thread: Board repair Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Snowboarding Forum - Snowboard Enthusiast Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
04-30-2014 07:07 PM
VincentOlenik I used to use 5 minute epoxy on boards and hold them together w/ C clamps from home depot while they were drying. I never had anyone come back complaining saying it came apart again.

Did you rip an edge out? I don't care how good the tech is that is doing the job, if you ripped the edge out the board will never ride on that edge the same again.. So at that point you have to decide if your going to spend money for a new board, or a not so cheap fix. It's just flat out almost impossible to get a new edge into a board and make it ride the way it did before. You'll feel it, especially if your board has a lot of tunes on it and any part of the new edge is higher than the old edge.

Also if you do edge replacement, don't act shocked when it ripps out of the board the next time you have it stone ground. I've seen that happen quite a few times.
04-26-2014 09:14 PM
ThredJack Pics, or you're an ass.
04-26-2014 04:40 PM
Donutz Also, is it new and still possibly under warranty? Or is it an old beater board from craigslist? Is it an expensive board, or a low-end POS?

"Hi, I have some stuff and it's not working. How do I fix it?"
04-26-2014 03:50 PM
FalseFlag Pics of damage
04-26-2014 03:48 PM
Board repair

So I got a board but the lamination on the bottom is peeling off and the metal on the edge is peeling off (I forget what its called). Could I fix it or do I need to take it to a shop or is it useless?

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome