|Topic Review (Newest First)|
|02-04-2010 12:36 PM|
Orange cleaner, green 3M pad, elbow grease.
Scrub the shit out of it, wipe it down with water to remove the cleaner. Your board will be dry as hell. It will LOOK like there's a white film on it, but it's not a film at all, it's your base without any wax.
Then you're good to go for a fresh wax.
|02-04-2010 12:33 PM|
of course kerosene will work, but it's not environmentally friendly.
Any citrus based houshold cleaner or "simple green" works just as well and without the guilt. Hell, you can even use plain lemon or orange juice and it'll work.
|02-03-2010 09:53 PM|
|Prophecies||My board is brand new, it's a Neversummer premier F1-R. I did notice it after using base cleaner. In fact, it might be that too. I can scrape it off. Also, I'm pretty sure I did a good job waxing it.|
|02-03-2010 09:42 PM|
|somebodyelse5||base cleaner is essentially just kerosene. so go get some and clean her up nice and re wax it|
|02-03-2010 08:58 PM|
I sprayed my black base with Swix base cleaner and it had a white film on it. Is this the base cleaner that you used??
|02-03-2010 08:34 PM|
Yea..you could scratch at it a bit with your finger nail..
if wax comes up its just excess wax
if nothing comes up your board is dry and needs waxing
|02-03-2010 08:13 PM|
|Boardski||Sounds like it's built up wax deposits. Is it on the opposite side fo your bindings? Thats a common spot I see it in my shop. Other areas may be the board warping. How old is your board?|
|02-03-2010 06:41 PM|
umm, could be where you're riding: is it east coast or midwest ice? That stuff's really abrasive.
Could be the type of wax you used may be wrong for your area/conditions.
Could be you just didn't do a very good job...did you hot wax with an iron?
Finally, some base materials are better than others...what brand board is it and are you sure it's a sintered base and not extruded?
|02-03-2010 05:45 PM|
White haze on base
After freshly waxing my board (sintered base) I took it up for a day's ride. However, after inspecting my board after riding, I noticed some sort of white haze on the base of the board in various spots. Not everywhere though. Does this mean my board is due for another waxing? I was only riding for about 3 hours that day. Otherwise, what is the cause of this?