Snowboarding Forum - Snowboard Enthusiast Forums - Reply to Topic
Thread: canted footbeds and binding angles Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Snowboarding Forum - Snowboard Enthusiast Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
11-26-2012 02:52 PM
krankedmusic 2 degrees puts too much pressure in one spot. My front is almost 32 degrees and my rear is 23 a lot of the pressure is releaved through out the boot instead just the toes. Stand naturally measure the angles that your foot naturally stand and try putting your bindings at those angels. Then adjust till their perfect.
11-26-2012 02:38 PM
Triple8Sol Nivek is spot on. The canting will allow you to run wider, which will prob feel more natural after a couple runs. I had to to the same when I first tried canted bases with the Ride NRc, Rome 390 Boss, etc... and am doing the same with my K2 Formulas now.
11-20-2012 01:16 AM
slowturtles hahaha i might just be a freak o nature! aight will do, thanks
11-20-2012 12:48 AM
Nivek Try riding at 23. I didn't get a numb foot riding my same stance width with canted footbeds, but it did feel off. Running a half inch wider made all the difference.

The canting just needs to be appropriate to you leg length and then just needs to match up with your stance width. With your leg length it just sounds like 22.5 is too narrow for a 2.0. Wider will take the pressure off the outside of your feet.

If that doesn't work you might just not be shaped right for canted footbeds. Freak.
11-20-2012 12:19 AM
canted footbeds and binding angles

so i gave canted footbeds a shot this weekend. I set them at 2 degree cant. My binding angles are 9 degrees on both feet. My stance width is 22.5 inches/10.5 feet/57.5 cm. I just measured the distance between the center of each binding.

So after a few hours of riding, the outside of my feet where the footbed is raised started to go numb from the pressure. This led me to think, are canted footbeds supposed to be for people with a wider stance? Or people with bindings set at higher angles?

edit: I'm about 5'10 and 147 lbs.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome