|Topic Review (Newest First)|
|12-24-2012 05:37 PM|
|12-24-2012 05:32 PM|
thanks for all the help. the board should be done in about an hour to cure. I've already taken the clamp off, as well as the two pieces of wood. It looks great, almost like there's no damage, except for the fact that there's a bit of white glue on the topsheet, but looks to be peelable, though i won't mess with it, for fear of creating a crack or something lol.
|12-24-2012 12:28 AM|
|12-23-2012 11:28 PM|
|12-23-2012 07:44 PM|
|hatsofftoya||i found a similar kind. I have my board sitting on a clamp between some wood. It's been sitting there for around an hour so far. How long should i keep it there for?|
|12-23-2012 04:30 PM|
|herzogone||From the looks of it, I think you should be able to clamp that no problem. As poutanen said, you should be able to use just about any general-purpose epoxy for a repair this small. A basic 2-part epoxy adhesive from a home improvement or auto parts store should be fine. It may not be an issue since the damage is fresh, but make sure the area is clean (ideally with acetone or MEK if you have it) and dry. Then mix the epoxy according to the directions and use a small disposable brush or spreader to coat both sides of the repair area. Clamp and let cure. Use enough to coat it but not so much it oozes everywhere. You might want to put wax paper between the topsheet and wood block or clamp just to ensure the clamp or block doesn't stick to the topsheet from any excess epoxy.|
|12-23-2012 04:13 PM|
LePage | 5 Minute Epoxy Syringe 25Ml | Home Depot Canada
It's hard to really see in the pictures, but you can try closing the gouge by hand, and if it will go back flat I'd try the clamp trick. Use a c-clamp or two on good flat chunks of 2x4 on either side. Clamp it first to test everything out, then slightly loosen the clamps, mix and pour your epoxy (it won't need much inside the crack, about enough to cover a dime)... Clamp it and leave for 24 hours.
Worse comes to worse if it doesn't work right, you could just cut/file away the loose piece of topsheet then pour some epoxy in the wound and shape it once it's cured...
|12-23-2012 04:04 PM|
Originally Posted by poutanen View Post
|12-23-2012 02:56 PM|
If the cut piece will lay flat again when pressed down, use a small amount of two part epoxy, spread it into the cut, then use two pieces of wood and clamp the shit out of the repair until the epoxy has cured. You may have to sand/file and epoxy that squishes out but at least the topsheet will be back in place.
If it won't lay flat, cut away any excess material and again use two part epoxy to fill the area. This time though you want to spread it evenly almost as if you're sculpting a new topsheet. Then again let it cure and sand/file away.
Epoxy does yellow over time so I've repaired edges that end up looking weird after a couple years. Who cares though as long as the board will still ride...
|12-23-2012 02:35 PM|
Topsheet board repair!! what do i do?!?
Hey there. I went snowboarding this past week only to have some noob hit me, knock me down, and slash up my park pickle as well! the topsheet is slashed, and the wood is somewhat exposed, although the wood itself does not seem to have taken damage. it appears that the topsheet was simply peeled off. how do i go about repairing this? i've done P tex for my base, but i feel this is an epoxy job (from what i've heard of those). Any insight/suggestions?