Snowboarding Forum - Snowboard Enthusiast Forums - Reply to Topic
Thread: Waxing question Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Snowboarding Forum - Snowboard Enthusiast Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
01-16-2009 10:49 PM
Originally Posted by stoepstyle View Post
best choice for you imo ahah just kidding
Probably right ..... What was I thinking, anyway ?
01-15-2009 10:52 PM
Originally Posted by Dawg Catcher View Post
4) kill yourself so you dont have to deal with this.
best choice for you imo ahah just kidding
01-15-2009 10:36 PM
Dawg Catcher
Originally Posted by Mosquitobug View Post
Any suggestion on how to prevent this ?
you have four options
1) be more careful
2) just wipe off when done its not that hard
3) dont wax your own board
4) kill yourself so you dont have to deal with this.
01-15-2009 10:25 PM
powderjet81 What I do when I wax is I turn the iron on really low and then touch the wax against it quickly. I then rub the block right onto the base. I can normally cover about 5 inches for each stroke, then touch it on the iron again. It leaves a thin layer of wax on there. It looks like a thin layer of paste over the base. Once I have got good coverage on the board I then just iron as normal.

By waxing this way I use a lot less wax, which means that i don't get excess everywhere, like over the edges. Its also more economical. Which i really like because I like to use fluorinated wax.

Another advantage is that because the wax is thinly spread it heats up faster and so I can iron at a lower temperature and don't need to hold the heat on there for too long. I dont have to use those extra seconds to melt the droplets before it spreads over the board.This helps avoid damaging the base.

It makes scrapping a lot easier as well because there is less to remove.

The only downside I find to this method is that it takes longer to apply it. But overall I find it to be faster.

If you do still end up getting wax on there use a citrus based cleaner, which you can find at most snowboarding outlets.
01-15-2009 09:21 PM
bobepfd just wipe it off when you're done. you can use some orange based cleaner or something.
01-15-2009 09:17 PM
KC KONG I just brush it off and if it does not come off right away then i just ride it off.
01-15-2009 08:56 PM
Waxing question

I tried my hand at waxing a couple of boards recently, and learned plenty. The videos and tips from this site were super-helpful and encouraging. The one problem I had didnt seem to be addressed anywhere -- I ended up with wax smeared on the topsheet of the tip and tail.

Any suggestion on how to prevent this ? Maybe I should just ignore....

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Powered by vBadvanced CMPS v3.2.3
For the best viewing experience please update your browser to Google Chrome