|Topic Review (Newest First)|
|02-21-2014 03:21 PM|
|czucker||Thanks for the advice.|
|02-21-2014 12:08 PM|
|stan_darsh||^^ i'd leave it too. nothing really wrong there.|
|02-21-2014 11:00 AM|
|poutanen||To be honest with you I'd probably leave that kind of stuff. If you're really worried, I'd use a dremel or file to clean up the area, and then fill with marine epoxy (some say the marine stuff stays more pliable)...|
|02-21-2014 10:48 AM|
|wrathfuldeity||Take a piece of sand paper and round off the topsheet edge, it will help reduce the topsheet peel when you get little nicks.|
|02-21-2014 10:08 AM|
|Psi-Man||Yea, a little epoxy there will do it, that's not bad.|
|02-21-2014 09:56 AM|
Edge Repair Advice
I'm very, very new to snowboarding, but not so new to fixing things. . .
I just picked up a used board and it has a few little dents along the edge. I'd like to do something to repair them so that the layers don't delaminate.
Attached is a photo of the worst of the dents.
What do you folks think, some wood glue and a c-clamp seem like the right idea?