|Topic Review (Newest First)|
|03-06-2014 05:03 PM|
Originally Posted by Soul06 View Post
i tried taking a pic, and its not visible with the eye, nvm my iphone camera.
I guess eventually ill have to sharpen it 88 degrees with a sharpener like everyone else.
|02-27-2014 11:13 AM|
I think I understand what he is asking here. If I am understanding correctly its not about the angles but that the metal has been shaved away so much that its almost nonexistent save for a thin razor like line of metal only at the bottom.
It would probably be better if you took an actual pic though
|02-27-2014 12:46 AM|
|Argo||Usually for racing you want like a 0.5-1 degree edge angle On the base and a 2-3 degree angle On the side. With a 0 it tends to be catchy.... They want it to engage when they get up on edge. Sbx guys usually have a 1/2 or 1/3 (base/side angle)done in the tune shop here that more than a couple sbx and ski racers use...|
|02-26-2014 11:42 PM|
You just added a second drawing that seems incongruous with the first one so now its hard to tell what you're up to there. A decent shop with a true bar and tools should be able to figure it out. If the old owner can't tell you, it's going to be impossible to tell visually without gauges or tools.
|02-26-2014 11:39 PM|
So your illustration is indicating that your base edge is zero degrees, flush with the bottom of the board correct?
In my experience a zero degree, dead flat base edge grabs really quick for obvious reasons. The side angle is difficult to estimate from your drawing especially when dealing with increments of 1 degree. But it could be a side bevel of only half a degree or a full degree. A lot of bordercross guys ride 90/89.5 or 90/89.
But the grabbiness on your finger could be caused by factors other than your edge angles. The steel quality of the edge can impact that and how recently it was sharpened.
|02-26-2014 11:28 PM|
Guys who know their edges : I need some help.
What kind of edge is this? I dont have a problem with it, but i would like to sharpen my other board like this as well.
It literally is just like the picture...The red sharp edge is JUST at the bottom. Is this a shop sharpening job? or??
because my other 90/88 edge sharpened board does not feel like there is a razor blade along my effective edge such as this one. The edge pulls on your finger.
If i were to hold the board standing on its tail, base facing me. I could let it fall forward and those edges alone could catch my fingertips and not fall.
I asked the shop at my local hill, and he said he cannot tell by the naked eye. Touching it didnt do it for him.
P.S. The guy who sold it to me said he did alot of carving...dunno if that helps.